![]() ![]() Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. In the Storage Mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimize gassing and corrosion of the positive plates. The Storage Mode kicks in whenever the battery has not been subjected to discharge during 24 hours. ![]() Less maintenance and aging when the battery is not in use: the Storage Mode If, in order to quickly charge a battery, a high charge current in combination with a high absorption voltage has been chosen, the charger will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached. Preventing damage due to excessive gassing: the BatterySafe mode After a deep discharge the absorption time is automatically increased to make sure that the battery will be fully charged. When only shallow discharges occur (a yacht connected to shore power for example) the absorption time is kept short in order to prevent overcharging of the battery. The right amount of charge: variable absorption time The ‘adaptive’ feature will automatically optimise the charge process relative to the way the battery is being used. The Phoenix Smart Charger features our well-known “adaptive” battery management system that can be preset to suit different types of batteries. ![]() Please see the manual for details.Īdaptive 6-stage charge algorithm: bulk– absorption – recondition – float – storage – refresh The charger compensates for voltage drop over the DC cabling by slightly increasing output voltage when the DC current increases. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery. Phoenix Smart (1+1): two outputs to charge 2 battery banks The wireless solution to set-up, monitor, control, update and synchronise Phoenix Smart IP43 Chargers. ![]()
0 Comments
Leave a Reply. |